Rheem GEN12S Installationshandbuch PDF herunterladen (Seite 14)

System Connections

Compare this illustration with your generator to familiarize yourself with the location of these important connections:

Wiring for the 10 Pole Connector:

• Fault Contacts — Use NO, COM and NC to hook up a

siren, light, etc. to alert for a fault. Contacts reverse

state upon a fault condition.

• Remote LED Output — Use this to hook up the remote

LED supplied with the generator. The remote LED will

turn on and off in a series of blinks (Fault Codes) if

certain faults are detected in the generator.

• Transfer Switch Communication — Use TxRx and

TxRx GND to transfer switch and optional wireless

StatStation™ to monitor generator functions.

• +12 Volt DC, .5 Amp Output — Internal power supply.

Wiring for the 2 Pole Connector:

• 240 Volt Utility — Use to hook up the 240V utility

leads from the transfer switch to the generator.

+12 Volt DC,

.5 Amp Output

240 Volt Utility

Remote LED Output

Transfer Switch

Communication

Fault Contacts

10 Pole Connector

2 Pole Connector

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 22 23

Keine Kommentare

Rheem GEN12S Installationshandbuch Seite 14