Rheem GEN20B Betreibershandbuch PDF herunterladen (Seite 15)

System Alert Mode – Standby System Faults

System Alert Display Fault Cause Fault Remedy

Switch G Coil Fail 1. Transfer switch generator coil failure. 1. Contact authorized service center.

Switch U Coil Fail 1. Transfer switch utility coil failure. 1. Contact authorized service center.

Generator Start Switch in OFF Position 1. Generator start switch in OFF

position.

1. Set generator switch to AUTO

position.

2. StatStation display too far away from

transmitter.

2. Locate display within 200 ft (60 m) of

transmitter.

3. Transmitter located in an area that

interferes with the transmitter RF

signal.

3. Locate transmitter in a location free

of RF interference.

4. Transmitter, generator, or transfer

switch signal wiring fault.

4. Contact authorized service center.

Fuse Fail 1. 2 Amp fuse in transfer switch failed. 1. Check/replace fuse.

2. Wiring failure. 2. Contact authorized service center.

One Wire Communication Fail 1. Signal wire failure between generator,

transfer switch, and transmitter.

1. Contact authorized service center.

Transmitter Battery Low 1. Transmitter batteries low. 1. Replace transmitter batteries.

StatStation System Fault

System Sync Unsuccessful 1. Batteries exhausted.

2. Display console too far from

transmitter or other signal

interference.

1. Replace with fresh AA batteries.

2. Move console closer to transmitter.

Replace transmitter AA batteries.

1 2 ... 10 11 12 13 14 15 16 17 18

Keine Kommentare

Rheem GEN20B Betreibershandbuch Seite 15