Rheem GEN20B Betreibershandbuch PDF herunterladen (Seite 7)

Sensing Wire Interconnections

All wiring must be the proper size, properly supported and

protected by conduit, per code.

Complete the following connections between the wireless

StatStation components, the transfer switch, and the

generator, as shown in Figure 3.

Figure 3: Transmitter Wiring Diagram

IMPORTANT: Observe the maximum signal wire distance

limitation (50 feet or 15 meters) on wire runs described in

steps 1 to 6 below.

1. Using installer supplied 18AWG stranded wire, connect

transmitter’s ground terminal (J4, 7th terminal from

left), to ‘GND’ terminal on transfer switch control board

(J7, leftmost terminal). See Figure 3.

2. Using installer supplied 18AWG stranded wire, connect

transmitter 8th terminal from left on J4 to ‘T’ terminal

on transfer switch control board (J7, 2nd terminal from

left).

WARNING

• Failure to follow above warning could cause personal injury,

damage and/ or malfunction of equipment.

Low voltage wire cannot be installed in same

conduit as power voltage wiring.

CAUTION

• Remove all power prior to installing this wireless StatStation

equipment. Failure to do so could cause internal damage to the

components when making electrical connections.

• Turn generator to OFF position.

• Turn off utility power to the home standby generator and

transfer switch.

Improper installation can cause damage to the circuit

boards and shorten their life. Installing circuit boards in live

circuits will damage the board is not a warranty condition.

ALWAYS disconnect ALL sources of power prior to

installation.

Main

Circuit

Breaker

Panel

Neutral Bus

Ground Bus

Automatic

Transfer

Switch

Wireless

Transmitter

Generator

Enclosure

Generator

Control

Panel

TxRx terminals

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare

Rheem GEN20B Betreibershandbuch Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Stromgeneratoren Rheem GEN20B