Rheem 871026 Betriebsanleitung PDF herunterladen (Seite 57)

CONNECTIONS – ELECTRICAL

All electrical work and permanent wiring must be carried out by a qualified person and in accordance with the

Wiring Rules AS/NZS 3000 and local authority requirements.

Warning: Temperature controllers must not be fitted to this water heater (871 series) as part of a solar

water heater system or if a Water Star water heater is installed because water at a temperature much higher

than the controller setting can be delivered. If a solar preheater or Water Star water heater has been installed

to an existing water heater installation, then all controllers must be disconnected and removed.

The water heater is supplied with a 1.8 metre lead and plug and requires a weatherproof 240 V 50 Hz

general purpose outlet (GPO) to be located within 1.2 metres of the installation. The GPO must be clear of

the flue exhaust, draining water, gas supply pipe and water connections.

The power consumption of the water heater is:

Component

Power

consumption

Comments

Gas water heater

64 Watts

66 Watts

022, 024, 026 – Burner on, anti frost device inactive

018, 020 – Burner on, anti frost device inactive

150 Watts

Burner on, anti frost device active

The water heater will only operate on a sine wave at 50 Hz. Devices generating a square wave cannot be

used to supply power to the water heater.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 75 76

Keine Kommentare

Rheem 871026 Betriebsanleitung Seite 57