Rheem 871024-B Spezifikationen PDF herunterladen (Seite 63)

General Construction

Part B – Specification and Response Requirements

Annexure 2- Minimum Design & Construction Specification

Page 63 Updated 19/07/2013

3.11.3.5 Grab rails including hand held showers attached to a grab rail

Where specified to be installed as part of the construction in Part B - Specification &

Response Requirements ANNEXURE,;

Grab rails are to be 32 mm in diameter and a min of 1.2 mm wall thickness and shall be

either stainless steel 304 or white powder coated ripple finish aluminium.

The fixing flanges shall allow for at least 4 x 6 mm diameter fixings. Use a fixing in every

fixing hole.

Fixings to timber support trimmers shall be with stainless steel size 10 or larger screws with

at least 30 mm embedment into the timber.

For fixing to masonry walls, use 6 mm stainless steel masonry anchors.

Where a towel rail is required to be able to be used as a grab rail,.a complying grab rail shall

be installed as the towel rail.

3.11.3.6 Soap holder/WC toilet roll holder

Provide soap holder to shower and WC toilet roll holder adjacent to WC. The soap holder

shall not have any loose parts that can be accidently knocked off.

3.11.3.7 Vanity basin – All houses

Vanity cabinet is to be 900mm long x 500mm wide x 800mm high with laminated top and

doors and constructed of water resistant materials. Finished internally with white Melamine

shelving and edge strips

The hand basin is to be a 500mm x 450mm vitreous china semi recessed or recessed hand

basin.

A “P trap” is required with waste set in the wall to allow for later adaption’s.

The floor and wall tiling should continue below and above the cupboard and be sealed to the

cupboard.

The unit is to be supported on a brick hob with return upstand tiling

3.12. GLAZING

Glaze doors, windows and sidelights in accordance with AS1288 and AS2208.

Provide safety glazing to all glazed doors, and other areas as required by AS1288 and

AS2208. Identify each piece with an approved marking or label.

3.12.1 Shower Screens

Shower screens and cubicles shall be glazed with laminated or toughened safety glass.

Where provided the shower screen should be removable (ie. tiling is continuous under and

behind the screen).

Where the shower is directed towards the bath, toilet, hand basin or other fixture a shower

screen at least 900 mm long shall be provided. In the case of a bath the shower screen is to

be fixed to the top lip of the bath and shall extend to the floor where it protrudes past the end

of the bath, In all other cases the screen shall extend to the floor.

Where a shower is adjacent to a doorway or window a 200mm long glazed as a shower

screen is required to protect door frame or window reveal and mouldings.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 114 115

Kommentare zu diesen Handbüchern

Keine Kommentare

Rheem 871024-B Spezifikationen Seite 63

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Warmwasserbereiter & Kessel Rheem 871024-B